| Product Model ： | ZCT190AL-V1 |
| Measuring Range ： | ±90 ° |
| Output ： | RS232 |
| Power： | Voltage(12～36V) |
| Measuring Axis ： | Single Axis |
| Accuracy ： | 0.1 °-0.5° |
| Resolution ： | 0.1 ° |
| Application ： | Machinery |
| IP Degree ： | IP67 |
| Temperature ： | -40℃ ~ +85℃ |
ZCT190AL-V1 is a single-axis tilt switch developed and produced by Shanghai Zhichuan Electronic Technology Co., Ltd. It measures the angle range from 0 to 90 degrees and is output through the RS232 serial communication port. The switch operating point can be set by the user’s command. Can be widely used in the field of construction machinery.
Feature:
All industrial devices are used, with stable and reliable performance
Impact resistance greater than 10000g
Allows a wide range of power supply, with reverse power protection
Adopt cast aluminum shell, protection grade IP65
Products passed CE certification
Application
crane
Hoist
Aerial vehicle and lift
Security control, monitoring, alarm
1)Technical parameters：（Typical values is under room temperature 25℃, unless special marked）
| Item | Condition | Min. | Typical | Max. | Unit |
| Supply Voltage | 8 | 12 | 36 | V（DC） | |
| Static working current(1 | Horizontal non-load Vcc=12V | 25 | 50 | mA | |
| alarm working current(1 | VCC=12V | 60 | mA | ||
| Alarm angle | Relay action point | 0 | 70 | 90 | ° |
| Working temp. range | －40 | +85 | ℃ | ||
| Measure range | Single axis | 0 | 90 | ° | |
| Resolution(1 | 0.1 | ° | |||
| Accuracy(2 | Room temp( 25℃±4℃) | ±0.5 | ° | ||
| Absolute zero point deviation | -20～+60℃ | 1.5 | ° | ||
| Respond time(3 | 1 | s | |||
| Housing size | Without plate | 80*75*58 | mm | ||
| Cable length | 1．5 | m |
Note 1: The static working current refers to the working current of the device when the power supply voltage is 12V and there is no alarm signal output.
Note 2: Accuracy refers to the root-mean-square error of the actual real angle and the sensor measurement angle measured multiple times (≥16 times).
Note 3: When the input angle reaches the set angle and the device outputs an alarm signal, the time required is the response time.
